基于com的网络爬虫程序，c++语言编写，写得相当简洁，个人认为很不错...

状态1：正常时，8个LED发光二极管（彩灯）循环点亮。 • 状态2：有报警时，蜂鸣器发出报警声（用P3.3接一个按键，模拟产生报警信号。当开关合上，发生报警；当开关断开，报警停止。用P3.7输出音频信号驱动扬声器，作为报警信号），同时8个LED发光二极管（彩灯）闪烁。 P3.2接一个按键，用于消除报警-Status 1: normal, eight LED light-emitting diodes (lantern) light cycle.

利用KF1208进行语音录放1. 按键配置: IOA8 : 录音 IOA9 : 停止 IOA10: 播放 2. 使用IOA0~IOA7作为数据IO 0~7,IOB0~IOB5 作为控制信号线-KF1208 use voice recording 1. Button to configure: IOA8: recording IOA9: stop IOA10: Play 2. IOA0 ~ IOA7 used as a data IO 0 ~ 7, IOB0 ~ IOB5 as a control signal line

LT-1B开发板例子程序－ADC12_06

ALTEA EPM7128 CPLD的用于控制三维步进电机的VHDL源代码-ALTEA EPM7128 CPLD is used to control the stepper motor of three-dimensional VHDL source code

基于vriloge的数字钟具有调时、分、秒和定时报警功能，开发环境是MAXPUII的开发环境，实际检验是完全符合-Vriloge based on the digital clock has adjusted hours, minutes, seconds and time alarm function, the development environment is MAXPUII development environment, the actual test is fully consistent with the

自己写的小程序，关于世界时钟的 有兴趣的同学可以看一下

此为锁相环函数发生器 包括键盘扫描程序 频率显示程序 波形显示程序-This is the phase-locked function generators including the keyboard scanner frequency waveform display shows process procedures, etc.

串口通讯经典使用程序4,以前收集整理的东东,希望对大家有用!-Serial Communication Classic to use the program 4, previously collected Dongdong finishing the hope for all of us!

C8051F040 ＣＡＮ总线编程，演示时需两块０４０的开发板，开发板的按键状态通过CAN总线发到另一个开发板上并通过ＬＥＤ显示出按键状态．-C8051F040 CAN bus programming, presentation 2 040 when the development board, development board through the state of the keys issued to another CAN bus and through the development of on-board LED shows the status button.

单片机usb2.0通讯-the conmunication of MCU by USB2.0