单片机波特率程序

数字电压表是ＳＴＣ单片机控制，四挡开关，０－１００Ｖ电压-Digital voltage meter is a single-chip control of STC,四挡switch ,0-100V voltage

实验箱上的蜂鸣器发出对应的音调（中音），当同时按下L和1-7时是，蜂鸣器发出低音，同时按下H和1-7时，蜂鸣器发高音。只要按键没松开，蜂鸣器一直发声，直到松到按键。-The buzzer sounded on the test box corresponding to tone (Tenor), when at the same time when you press the L and 1-7, the buzzer sounded a bass, while pressing the H, and 1-7 when the buzzer made treble. As long as no release button, buzzer sound has always been, until the pine to the button.

本文档说明AVR单片机的Atmega 16对键盘按键控制的程序-This document explains AVR MCU Atmega 16 the keyboard keys to control the procedures

msp430F149 timer模块程序，很好用-msp430F149 timer module procedures, good use

电子密码锁程序，两键输入，其中一个键累加，另一个键确认。密码正确锁打开（开锁指示灯亮）；密码错误锁关闭（关锁指示灯亮）；连续错三次则锁定键盘8秒并发出报警声。-Electronic code lock procedure, the two key input, one key additive, and the other button to confirm. The correct password to open lock (unlock indicator light) password error lock closure (Kuan-lock indicator light) consecutive wrong then lock the keyboard three times and issued eight seconds alarm sound.

以上程序使用PIC12C508单片机，内部4MHZ时钟，4脚输入50HZ脉冲信号，7，6，3脚（GP0，GP1，GP4端口）为输出口。其中渐变部分是让灯慢慢的变亮（或灭--It uses PIC2C508 SCM, 4MHZ clock, 4 port is for inputting 50HZ signal, 7/6/3 port for output.

报警电路 单片机控制的自动报警器 C程序和汇编编写-Single-chip control circuit alarm alarm automatic compilation of procedures and the preparation of C

自行车里程设计的远程序 他的用途很实际的 并且说明详细-bicycle mileage from the design process he uses a very practical and detailed note

U2270B，对U2270B芯片进行了详细介绍。-U2270B, on U2270B chip described in detail.

用51单片机驱动2.0TFT（S6D0128）。-with 51 Microprocessor 2.0TFT (S6D0128).