控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序...

凌阳的LCD演示原码,里面还有LCD的使用说明.

单片机下载工具STC-isp-v3.93版本解压即用绿色软件-Download tools Singlechip STC-isp-v3.93 versions of decompression that is green software

1.电子琴功能 用实验板上K1~K7作为电子琴的7个按键，每个按键对应一个音符要求当按下其中一个按键，就通过P2.5口输出对应频率信号使蜂鸣器发出特定音符声音。 2.乐曲演奏 若按下K8键，完成自动弹奏“送别”歌曲。 -1. Organ function of the experimental board K1 ~ K7 as the organ of the seven buttons, each button corresponds to a note of which require that when the press of a button, on the adoption of P2.5 port output frequency signal corresponding to a specific note to the buzzer sounds . 2. Music playing, if pressed K8 button to complete the auto-play " Farewell" songs.

51单片机直接驱动液晶显示，里面有两个程序！-51 Single-chip Direct Drive Liquid Crystal Display, which has two procedures!

各种单片机反汇编软件包,方便程序的调试! -Disassemble a variety of SCM software package, to facilitate program debugging!

凌阳061a单片机的中断使用例程。包括外部中断例子-Sunplus 061A MCU interrupt routine use. Including external interrupt example

usbio的上位机动态连接文件，Ver 2.41-PC usbio the dynamic link file, Ver 2.41

PROFIBUS SLAVE PROGRAMS PRO FIBUS SLAVE PROGRAMS

用C写的I2C总线EEPROM读写程序，在MSP430＋AT24C64～512平台上验证通过。对其他处理器只需简单修改即可使用。-C write I2C EEPROM read and write procedures, the AT24C64 MSP430+ ~ 512 platform validation through. The only other processor can use a simple amendment.

128*64点 LCD及DS1302 应用-128* 64 points, LCD and DS1302 Application