uc/GUI移植TFT6448底层驱动。

ＵＣＯＳⅡ嵌入式操作系统应用例子-UCOS II Embedded Operating System Application examples

ucos-II的shell开发，指示性代码，主要针对8051单片机，包括相关控件函数（转载）-CENTER-II shell development, indicative code, mainly aimed at 8051, including relevant control function (reproduced)

ucOs-ii完整源代码，极其方便用户调用-ucOs-ii complete source code, an extremely user-friendly call

基于 proteus + LCP2131的ARM开发,包括proteus电路连接图,ucoss II的串口通讯程序等-Based on proteus+ LCP2131 the ARM development, including Proteus circuit connection diagram, ucoss II Serial Communication procedures

uCOS2.86源码,并已在ARM7上移植成功！！！(This is the code for uC/OS-ii)

基于嵌入式实时多任务操作系统ucos－ii的GUI的源码，精炼实用-Source code of GUI based on ucos-ii, very small and useful.

完成在S3C2410处理器上移植μC/OS-II内核，然后实现以下多任务： a) 控制实验箱核心板上4盏LED灯轮流亮灭； b) 将LED1连接到ARM9-2410EP增强型实验箱扩展口的DA OUT端口，通过实验箱上的键盘（比如“↑”、“↓”键）控制LED1亮暗变化，同时在超级终端显示该控制值； c) 将LED2连接到扩展口的I/O输出口，通过超级终端按键控制LED2亮灭，即按一下PC的超级终端某个键（比如回车键）LED2灭，再按LED2亮，反复循环。 -Completed the processor S3C2410 transplant μC/OS-II kernel, and then multi-task to achieve the following: a) control experiment box core board 4 bright LED lights out rotation b) will LED1 connected to the ARM9-2410EP enhanced experimental me expansion of the mouth of DA OUT port, through the experimental box on your keyboard (such as

基于 Philips 公司的 ARM-7 使用之 uC/OS-II 作业系统,此例程是移植于 LPC-2138 上的应用,不同于一般的 Porting 其最主要是加入了支援 OS_View 观察器功能,于 IAR EWARM V4.41A 工程编译,而 uC/OS 版本为 2.83-Based on the Philips company

本文介绍了_C/OS-II概况和ARM体系结构中与移植工作相关的一些概念，并在此基础上分析了基于ARM的移植工作。-_C/OS-II Profiles and the ARM architecture and transplantation related to the work of some of the concepts, and on the basis of this analysis based on the ARM transplants.

infineon的tricore版本uc/os，tc1796芯片使用(infineon' s tricore version of uc/os, tc1796 chip using)