这是一个LED液晶显示的程序...有多个接口..可以用的我用过

lpc2104驱动PG160128A点阵液晶源程序

单片射频收发器nRF905及其应用_设计nrf905.h文件-Single-chip RF transceiver and its applications nRF905 _ nrf905.h document design

我的一点点程序―红外解码程序-A little bit of my process- IR decoding process

通过EC的SMBUS接口读取电池信息，如电流、电压、温度等-read battery information via SMBUS in EC interface

PS2键盘设计---C51程序，详细介绍了对PS2键盘的响应和处理-PS2 keyboard design-C51 procedure, described in detail on the PS2 keyboard response and treatment

单片机的Demo，可以在单片机上演奏音乐 用汇编语言的写的

密码锁:根据设定好的密码，采用二个按键实现密码的输入功能，当密码输入正确之后，锁就打开，如果输入的三次的密码不正确，就锁定按键3秒钟，同时发现报警声，直到没有按键按下3种后，才打开按键锁定功能；否则在3秒钟内仍有按键按下，就重新锁定按键3秒时间并报警-Password Lock: According to set a good password, the password used to achieve two key input function, when to enter the correct password, the lock will open, if entered incorrect password three times, on the lock button 3 seconds, also found that alarm sound, do not press the button until the three kinds of after the Open button lock function otherwise, there is still a matter of seconds in the 3 button press, on the re-lock button 3 seconds time and alarm

利用MSP430 单片机的一般 I/O口进行的数字量的采集 利用A/D采集通道实现模拟量到数字量的转化-use of the general I/O port for the digital collection using A/D channel analog output of the digital conversion

用反转法实现快速高效的4*4键盘扫描，并通过串口将按键值输出-Inversion method with fast and efficient implementation of the 4* 4 keyboard scanning, and send out the key value through the serial port

内容为89c52单片机的基本实验 内容涵盖比较多 所采用的实验板是网上和容易找到的TX-1C。是新手比较好的参考资料-89c52 microcontroller content covers the basic experiments are more used in experimental board is easy to find online and the TX-1C. Is a good reference novice