单片机与FPGA通信的小程序，做的不好请多指教。谢谢了！这真是个好网站啊...

带遥控 带128*64LCD 带电子开关 -With remote control with 128* 64LCD with electronic switch

时钟日历芯片PCF8584的C51源程序，转载自于磁动力电子网-calendar clock chip PCF8584 source of C51, reproduced from the magnetic force on electronic network

使用IAR编译器开发的ATmega128的程序 有串口通信 IO口控制 定时器 SPI接口等等功能的实现-Use IAR compiler development process ATmega128 serial communication port to control IO timer SPI interface functions and so on to achieve

MSP430串口程序，串口接收与发送均用中断处理。当MSP430串口中断接收到PC机的指令后通过中断发送将数据发送出去。-MSP430 serial program, serial port receive and send all use interrupt handling. When the MSP430 serial receive interrupt instruction PC, adopted after the break to send the data sent.

这是基于ATMEL89S51上的一个电子时钟源代码程序,有相当完美的注释解说,希望对大家有所帮助.-This is based on the ATMEL89S51 on an electronic clock source code for the procedure, quite a perfect footnote to explain, and they hope to be helpful to everyone.

采用AT89C2051 稳压可调电源,0~30V 两个数码显-AT89C2051 using adjustable power regulator, 0 ~ 30V digital two significant

本地机使用ATDT命令拨号,远程机设为自动响应方式,即可进入联机方式, 进行终 端通信.在联机方式下,按PageUp键上载文件,按PageDn键下载文件,Ctrl-O呼出主菜单, 退出联机方式使用Ctrl-D键.退出终端仿真器主程序使用TC编写.终端方式为VT100.-Local machine using the ATDT command dial, the remote machine is set to automatically respond to the way, you can enter the line for terminal communication. In-line mode, press PageUp key to upload files, download the file by PageDn keys, Ctrl-O exhaled main menu , quit-line use Ctrl-D keys. withdraw from the terminal emulator to use TC to prepare the main program. terminal for VT100.

4442逻辑加密IC卡读写底层C51程序，-4442 encryption logic IC Card Reader bottom C51 procedures,

can总线应用

斜度计的MSP430程序，挺好的程序，大家-Gradient of MSP430 procedures, very good procedures for U.S.