a Mega8 SPI DataFlash code reader, is to use the C language. Visit Atmel AT45Dxx...

使用标准控件 Microsoft Communications Contro 进行串口设置，串口读写，读写输入输出缓存。-using standard controls for Microsoft Serial Communications Contro set, serial literacy, reading and writing input and output buffers.

学院系统，源代码详细描述，如有疑问，请与我联系。

实现图像控制,云台解码器控制,站点选择(配有Access数据库).-image control, pan and tilt control decoder, site selection (equipped with the Access database).

连接串口通讯程序，采用EVB书写模块，MScomm控件-Connect the serial communication program, using EVB writing module, MScomm control

eVC下操作串口提取GPS有效数据1，把文件名字后缀.rar去掉即可，不用解压缩。-operate under serial data from a GPS effective, the document name suffix. Rar can be removed without decompression.

C++Builder对串行口进行读写操作的一个通讯类-C serial port and write a communications

云台开发程序，VB环境。-Haeundae development process, VB environment.

一个VC++做的短信发送程序，在第一次运行的时候记得设置本地的区号，-A VC++ Message sent to do the procedure, the first time to remember to run set up a local area code,

在Labview开发环境之中,检验串口一个例子.-In Labview development environment, and test serial port a case in point.

本文讲述的利用通讯控件发送与接收通讯数据都是基于二进制来实现的，基于文本的情况基本与此类似。要想利用好通讯控件还有其他一些应该注意的地方，比如波特率的设置、接收与发送缓冲区的设置以及通讯过程中的延时问题的处理等等。-This paper describes the use of communications controls send and receive communications are based on the binary data to achieve, based on the basic text of this and similar. To make good use of communication controls should also pay attention to some other place, such as baud rate settings, receiving and sending the buffer settings and communication latency in the process of dealing with such problems.