PIC单片机与MAX517的串行通讯程序

NRF401芯片的C51发送子程序-NRF401 chip C51 sent subroutine

红外解码程序，该程序可为用户提供正确的解码方案，但前提是理解好每个红外的发送过程-IR decoding process, which can provide users with the correct decoding, but the premise is a good understanding of the sending process for each infrared

一款单片机开发板的资料，对于想设计开发板的人有知道作用，看看别人怎么做到的。-new microcontroller development board information for the design and development board would have to know the role and see how others do.

这是参加电子设计大赛时的作品：红外遥控小车：用红外线通过一块AT89S52单片机发射信号即编码，并用红外接收头接收信号；接着再用另一块AT89S52单片机对红外发射出的信号编码进行解码，最后再用一块AT89S52单片机用解码所得码值编写程序后驱动步进电机。步进机功能启动后不仅能使受控小车向前后左右四个方向前进和转弯，而且还能控制小车再地上转动并留下方形或圆形等形状。-This is the time to participate in Electronic Design Contest works: infrared remote control car: Using infrared transmission signal through an AT89S52 microcontroller that is encoded and used infrared receiver to receive the first signal and then using the other an infrared emitting MCU AT89S52 code and decode the signal and finally an AT89S52 microcontroller then proceeds with the decoding key value of the preparation of procedures to drive a stepper motor. Stepper machine function activated not only make the car forward in a controlled direction and after about four turns, but also to control the car and then turned and left the ground such as square or round shapes.

基于单片机的波形发生器，可产生方波，三角波及正弦波，频率可调。-Based on single-chip waveform generator to generate square wave, sine wave triangle spread, frequency adjustable.

公共汽车报站器,基于51-bus stop-based 51

LCD ――HT1621――PIC程序-LCD-- HT1621-- PIC procedure

LT_1B msp430开发板例子程序－TA_14

AD592温度传感器在Atmega8L下的测量程序-AD592 temperature sensor in the measurement procedure Atmega8L