In this experiment to learn how to use the CC2420 will be the address decoding f...

基于89S52单片机的4位LED显示，定时程序，定时器初值可以在程序中修改。-89S52-based MCU four LED display, the regular procedures Initial timer in the process of change.

AVR单片机入门及C语言高效设计实践(13)源程序码-AVR单片机入门及C语言高效设计实践13)源程序码

使用AT98S51控制1602液晶显示程序，AT89S51使用12M晶振。

cc1100 rf init 如何初始化cc1100的发送与接受寄存器-cc1100 rf init how cc1100 initialization register of the sending and acceptance of

i2c 总线 at512读写程序，适用于8051系统单片机系统-i2c bus at512 literacy procedures applicable to the 8051 system SCM System

使用凌阳SPCE061A作为主控核，与液晶12864采用串行方式连接的驱动程序12864_Driver.c，开发环境为凌阳IDE2-Sunplus SPCE061A use as a master of nuclear, with LCD 12864 Serial driver connected 12864_Driver.c, development environment for Sunplus IDE2

单片机控制火车车厢门上方的LED显示程序-Single-chip microcomputer to control the top of the train compartment door LED display program

学习用，使用前，认真阅读，按实际情况更改IO口！-to study, use, read carefully, according to the actual situation changes IO mouth!

经典的DSP的C程序和汇编程序, 非常好!-Classic DSP-C procedures and compilation of procedures, very good!

从虚拟终端输入8个任意数据，通过串口传送给单片机的led_buf缓冲区，并在8个led上显示；按回车键对led_buf缓冲区中的数据进行由小到大排序，排序结果在led上显示。-From the virtual terminal eight arbitrary input data, through the serial port send buffer led_buf MCU and 8 led display led_buf press Enter to buffer the data from small to big sort, to sort the results in the led display.