this the usbtester program to browse the communicatino between host and device-this is the usbtester program to browse the communicatino between host and device

ucos2.52在msp430上移植-ucos2.52 transplant on the Controller

本例程uCOS-II 版本为2.51,仅创建一个LED闪烁任务于 P1.0 上,每隔 0.5 秒闪动一次,任务而此例程运行于内 RAM > 300 Byte 的51内核单片机即可。-This routine uCOS-II version 2.51, only the creation of a blinking LED on P1.0 on the mission, occulting once every 0.5 seconds, and this routine mission inside running on RAM

邵贝贝写的《嵌入式实时操作系统ucOS II》，最后面API参考手册，对每个函数的介绍页面都添加了目录，方便查阅。(Shao Beibei write embedded real-time operating system ucOS II, the rearmost API Reference Manual, on the introduction page for each function are added to the directory for easy access.)

What you will need to use μC/OS--What you will need to use μC/OS-II

一个适于8位单片机使用的TCPIP---uip源码 uip-one for 8-bit microcontrollers used in TCPIP--- East source East

STM32F303的UCOS工程 支持硬件浮点运算 具有OLED屏显示 具有2路DA功能 具有AD采集(The STM32F303 UCOSII project Support floating-point hardware With the OLED screen display With 2 DA function With AD acquisition)

keil mdk 3.22下移植的uCOS II 2.83，可在板上RAM中直接调试。-keil mdk 3.22 transplantation under uCOS II 2.83, on-board RAM can be directly debugging.

ucos实时操作系统移植的讲解，可以参照移植到ARM处理器中-ucos real-time operating system migration talks, can refer to transplanted into the ARM processor

ucos在blackfin533上的移植。用ADI的visual dsp++ 编译。如果编译不能通过，请将*.ldf删除，让系统自动生成ldf文件。-CENTER blackfin533 in the transplant. Using ADI"s visual DSP compiler. If you compile passed, I would be grateful if*. ldf deleted, so that the system automatically generate ldf document.