EXTInterruptFIQ.rar 44B0快速中断、外部中断程序

嵌入式系统(基于ARM Samsung44BOX芯片)的USB口调试程序的源代码!-embedded system (based on ARM chip Samsung44BOX) USB debugging program"s source code!

STK6031 MCU,64KFlash UART 程序-UART FUNCTION

FM1755驱动 +arm keil编译环境，有LPCD功能，分为TYPEA,和TYPEB卡识别

PTR8000(ControlVoice)源代码-PTR8000 (ControlVoice) source code

2440 开发板user guide 大致介绍了 开发过程-2440 development board user guide broadly introduce the development process

ARMBOOT源码1.0.1 ＡＲＭ嵌入式开发启动通用代码．-ARMBOOT source 1.0.1 ARM Embedded Development launched generic code.

STM3210B-EVAL_Demo -STM3210B-EVAL_Demo

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

三星S3C2440 IIS控制器驱动程序 -Samsung S3C2440 IIS controller driver

mc9s12XDP512 单片机PIT0 程序-mc9s12XDP512 MCU PIT0 program