收音机程序，大家分享一下吧！！！！1 大家也帮忙看看写的对不对...

U盘(实际是USB SD卡读卡器)的制作方案。 硬件构成：ATmega168+PDIUSBD12+SD 内附GCC源码和原理图。 开发环境是AvrStudio4.13 b528 + WinAVR200701-U disk (actually USB SD card reader) production program. Hardware: ATmega168+ PDIUSBD12+ SD containing GCC source code and schematics. Development environment is AvrStudio4.13 b528+ WinAVR200701

16*16点阵，可能显示汉字，同时可以放出音乐-16*16

打印机控制程序，用89c52单片机控制打印，已测试通过-printer control procedures, 89C52 microcontroller with print control, have been tested

mcu_PPP在一个单片机上实现PPP协议详解.rar-mcu_PPP in a microcontroller to achieve PPP Elaborates on. Rar

计算机简单控制由软件和硬件组成。软件由Visual Basic 6.0编写。硬件主要由无线发送模块和单片机（C语言编写）构成。通过RS232界面与PC通信而实现无线控制系统。 主要功能是：通过遥控器连接PC机的"上下左右"按键 ,当电脑界面处于powerpoint界面下,能通过遥控器控制幻灯片的上下切换. -Simple control by the computer software and hardware components. Software prepared by the Visual Basic 6.0. Hardware mainly by the wireless sending module and single chip (C language) constitute. Through the RS232 communication interface with the PC wireless control system. Main function is to: Connect PC through a remote control machine up and down about button, when the computer interface in a powerpoint interface via remote control to switch slides up and down.

51单片机的多机串口互连 通信函数，提供缓冲区，通过P2口的输入决定从机号。在STC89C52，AT89S52上通过。-51 Single-chip interconnection of multi-machine serial communications function, providing a buffer, through the input port P2 from the machine its decision. In STC89C52, AT89S52 adopted.

conver hull prgram dds

弄电路图弄逼曙开工率显形立即jklda蝠a-塞住的嘴、‘nfggf

SST89E58RD仿真器的制作有关的PCB,说明和监控程序,可以用来对51单片机进行仿真-SST89E58RD simulator produced the PCB, description and control procedures can be used for 51 single-chip simulation

这是sd/mmc卡程序地而部分内容，后面还有！-This is the sd/mmc card program and part of the contents in the back there!