英飞凌C166之XC164CS双CAN通讯程序

18b01驱动采用单片机显示18b20温度驱动

usb-串 口 转 换pcb板 图,pcb格式-usb-serial conversion pcb map, pcb format

I2C通信的程序，用VHDL写的，可用于FPGA和单片机的通讯。-I2C communication procedures, written with VHDL, FPGA and MCU can be used for communications.

ELAN IR接收，1621段码LCD驱动，按键处理，三线通讯等。-ELAN IR receiving, 1,621 yards of the LCD driver, keys, 3 line communications.

TI的S6700芯片与ISO/IEC15693标准的读卡器设计，包括起始位，结束位，数据收发的子程序-TI" s S6700 with the ISO/IEC15693 standard reader chip design, including the start bit, end bit, data sent and received subroutine

实现CAN总线通讯的自测试功能，如果硬件条件具备，也可用来实现CAN控制器之间的通讯。 具体内容见代码中每一句的注释，经调试成功-CAN bus communication realize the self-test function, if hardware conditions are ripe, but also can be used to realize communication between the CAN controller. The specific content of the code, see the Notes of each sentence, after the successful commissioning

JUPITER演示程序，SIO-test-JUPITER demo, SIO-test

一个用GCC做的atmel芯片控制的无刷无传感器的程序.包括各种参考文档!

TELEPHONO的C51程序-TELEPHONO procedures

该程序是单片机ATMEGA103通过GPIO口模拟SPI总线协议的SPI读写函数-The program is through the GPIO port ATMEGA103 Singlechip simulation SPI bus protocol of the SPI read and write function