好东西共享给大家,液晶显示的1502的,单片机51系列

51单片机汇编指令工具包-51 SCM compilation instructions Kit

Atmel SPI Master C51程序-Atmel SPI Master C51 procedures

C51的45D驱动程序-C51 45D Driver

3.多路舵机控制电路C语言版 C51-3. Multi-channel steering gear control circuit C language version of C51

AVR单片机MEGA128-UART的程序原代码-AVR Singlechip MEGA128-UART procedure for the original code

单片机C51控制，实时时钟程序，单片机掉电后重新启动仍能准确显示时间-C51 single-chip control, real-time clock procedures, single-chip power-down after the restart time can accurately show

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

按键控制发光二极管熄灭，基于凌阳单片机开发 -Button control LED is off, Sunplus based on single-chip development

51单片机可在线编程多功能实验板使用手册 内附多个实验程序（供初学者参考）-51 Single-chip can be online programming multi-function board user manual containing a number of experimental procedures (for beginners reference)

串行EEPROM芯片资料,用单片机引脚二线制访问-serial EEPROM chip information, Two-pin MCU visit