提取、刷写飞利浦713X系列电视卡EEPROM（识别码）

总结前人经验,改进后的程序,虽有警告但是仍可应用.因为8个警告中有7个是因为函数定义后未调用.-Summary of previous experience, improved procedures, despite a warning but can still be applied. Because there are eight warning is because the seven did not call the function definition.

关于CY68013 USB2.0控制输入测试的程序.想了解USB开发的可以看看.-CY68013 USB2.0 control input on the testing procedures. Would like to know can look at the USB development.

视觉暂留，编程从一个I/O口输出一扫频信号，驱动一支LED灯闪动，频率范围为10HZ~99HZ，扫描时间为30秒，在LED闪动期间观察，一旦发现无法识别LED灯闪动时，按下按键K1，立即停止输出，并将此时的信号频率显示在数码管上，该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequency range of 10HZ ~ 99HZ, scan time of 30 seconds, the LED flashing during the observation, once found it impossible to identify the LED lights flashing, press the key K1, immediate cessation of the output, and at this time the signal frequency displayed on the digital control on the test cycle of the signal" s persistence of vision time.

主要是51单片机的全套应用及其程序源代码-Is a complete set of 51 single-chip applications

维根输出源程序用kei uvision打开！-Victoria-source output with Kei uvision open!

430中149单片机使用的UART的特殊用法，测试通过-430code

modbus的单片机程序。应用于单片机通信。-Modbus Microcontroller procedures. Applies to single-chip communications.

采用C51编写的基于C8051F020单片机排序实例。-using C51 prepared by the C8051F020 ranking examples.

无刷直流电机控制程序，通过PIC18F2431控制。-Brushless DC motor control program, through the PIC18F2431 control.

用AT89S51单片机控制的1602液晶屏程序，-AT89S51 MCU with LCD 1602 procedures,