使用MEGA16L控制NRF24L01接收数据

c51程序原理. .-principle

ks0108 12864 液晶的C语言驱动-ks0108 12864 LCD C-language-driven

有关键盘接口的程序，我自己弄的，希望有帮助-Procedures relating to the keyboard interface, I get and I hope that helps

德国KVASER公司关于MCP2510驱动的源代码-Germany KVASER company on the MCP2510-driven source code

tl2543的AD程序仅供参考--KEIL51！-tl2543 the AD process is for reference only KEIL51!

单片机，与PC 串口通讯 程序-Microcontroller, and PC serial communication program

LED 灯闪烁程序-LED lights procedures

这是在KEIL环境下写的CAN源码，具有CANOPEN协议，学习参考的好东西哟！-This is in KEIL environment CAN write source code, with CANOpen agreement, a reference to learn good things yo!

利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"。到此保持住。 设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital control to show from the beginning of 765,432 to 1/10 seconds until the speed of descending down 765,398 and maintain display this number, at the same time the use of Timer 0 to 500ms the speed of light from the flowing water to Under the move, when reduced to a few digital tube stop, the experiment on-board water stop and then all the lights started to flicker, 3 seconds later (T0 regularly used) closed water lights, digital tubes show

x9313数控电位器的驱动函数，用于程控LCD对比度，-NC Potentiometers x9313 driver function for program-controlled LCD contrast,