ch451驱动数码管,一按键多功能程序,24C02实现易丢失数据储存-ch451-driven digital control, a key multi-function programs, 24C02-volatile data storage to achieve

9052开发-9052 Development

这只是我在学习TI公司生产的16位超的功耗单片机MSP430的随笔，希望能对其他朋友有所借鉴，不对之处还请多指教-This is only my TI in the learning produced by 16-bit single-chip MSP430 ultra-power of the essay, hoping to draw on some other friends, doing so also please advice

自制小时钟 可以遥控调节时间，采用315M 2262 ，2272 收发模块 发来给新手看看 -Self-made small-time clock can be adjusted remotely, using 315M 2262, 2272, sent to the transceiver module to see if novice

单片机KeilC学习例程，不需要数点基础，可以掌握C51的使用-Microcontroller KeilC learning routines, no basis for a number of points, you can master the use of C51

ATmega8-使用Protues仿真,让你不用开发板也可以学到单片机.-ATmega8-use Protues simulation, so you do not have development board can also be learned Singlechip.

单片机音乐播放程序，附带三首已编音乐代码，音乐调声可调-Singlechip music player program, three have been incidental music code, music, acoustic tune adjustable

自己写的1621驱动程序（绝对可以用的，针对NEC单片机的）-Write your own 1621 driver (certainly we can use for NEC MCU)

Verilog实现的DDS正弦信号发生器和测频测相模块，DDS模块可产生两路频率和相位差均可预置调整的值正弦波，频率范围为20Hz-5MHz，相位范围为0°-359°，测量的数据通过引脚传输给单片机，单片机进行计算和显示。-Verilog realize the DDS sine wave signal generator and frequency measurement module test phase, DDS module can generate both frequency and phase difference can be preset to adjust the value of sine wave, frequency range of 20Hz-5MHz, phase range of 0 °-359 ° , measurement data and transmit them to the single-chip pin, single-chip microcomputer to calculate and display.

这是msp430与1335的接口控制程序，控制320*240的液晶显示驱动。-This is the MSP430 with the 1335 interface control procedures, control 320* 240 LCD display driver.