verilig准备使用CPLD读写EEPROM（74lc21）程序

sja1000两点通信实验，从程序即可看出硬件连接-SJA1000 two communications experiment, the procedure can be seen from the hardware connection

VHDL编写的八位9值信号的中值输出方法，特点是不采用流水或状态机设计，因此速度较快-VHDL prepared by eight of the nine value signal output value method, which is characterized by not using water or state machine design, therefore faster

中间配套传感器的测试 avr 有很多地方需要改进-middle matching sensor test avr many areas need improvement

DS18B20测温程序 DS18B20测温程序-DS18B20 measurement procedures DS18B20 temperature process

关于CPU卡最浅显易懂的介绍资料，内容详尽，适合对CPU卡所知甚少的新手阅读。-On the CPU card of the most easy to understand introduction to the information, content, detail, suitable for CPU card little was known about the novice to read.

这是一个接收单片机数据的软件,通过对接收的数据分析来显示相应的LED.目前只能显示一个LED,有时间会全部做好的,目前接收到的数据为0A0B0C,也就是从单片机发出来的数据为10,11,12,单片机的程序是a-This is a single-chip microcomputer software to receive, through the analysis of data received to display the corresponding LED. Currently only display a LED, will all have time to do a good job of currently received data 0A0B0C, that is, from a single machine sent to the data for 10,11,12, SCM process is a

Test program for AVR

基于16位单片机的符合osek标准的操作系统，在freescale的16位单片机上调试通过-Based on 16-bit MCU line with the OSEK operating system standard, in the Freescale 16-bit single-chip debugging through

用单片机与CPLD做的等精度频率计，误差精确到十亿分之一-MCU and CPLD make use of such precision frequency meter, the error is accurate to a billionth of a

Keil　C的调试经验-Keil C debugging experience