LPC915的I2C模块配置为主机时的接口程序，可直接添加到工程里使用...

PIC上实现的I2C通讯源程序，使用IO口模拟I2C总线时序来实现的。-PIC achieve I2C communications source, I use IO I2C bus timing simulation to achieve.

图形液晶TG12864B-2驱动程序-Graphic LCD Driver TG12864B-2

基于Proteus的正反转可控的步进电机的仿真，内有源代码。-Based on the positive inversion Proteus controlled stepper motor simulation, within the source code.

利用单片机产生pmw，控制led，修改后可控制直流电机-Single-chip computer generated pmw, control led, modifications can be controlled DC motor

单片机的Demo，可以在单片机上演奏音乐 用汇编语言的写的

320x240图形液晶驱动程序。经验证可以使用-320x240 graphic LCD driver. Certified can use the

本程序主要通过外部中断INT0及3.3端口读取PS2键盘值并通过LCD1602显示，键扫描码的解码通过数组方式解码，程序的解码功能主要针对数字及大小写字母和常用标点符号 硬件描述：PS2键盘的时钟线（clk）接89S51的INT0（P3.2）,数据线data接（P3.3） LCD的控制端口分别为： RS = P2^7，RW = P2^6，EP = P2^5，数据端口为P0，液晶显示偏压VL必须接 -This procedure mainly through external interrupt INT0 and 3.3 read PS2 keyboard port value through LCD1602 display, key scan code decoder way through an array of decoding, the procedure for decoding function of the major figures and upper and lower case letters and punctuation marks commonly used hardware description: PS2 keyboard clock line (clk) then 89S51 the INT0 (P3.2), data lines data access (P3.3) LCD control port, respectively: RS = P2 ^ 7, RW = P2 ^ 6, EP = P2 ^ 5, data ports for the P0, LCD bias VL must be received

DS1302实时时钟的MSP430单片机底层驱动程序 -DS1302 Real Time Clock Driver MSP430 Singlechip bottom

MICROCHIP滚码接收和存储程序。官方程序-MICROCHIP rolling code receiver and storage procedures. Official procedures

介绍了液晶显示模块基本原理及其技术特性，与单片机的进行接口的具体电路，同时给出了其编程方法和程序代码．-Introduced the basic principles of liquid crystal display module and its technical characteristics, and MCU interface to the specific circuit, at the same time gives the methods and procedures of its programming code.