rc500 c语言库函数，对RC500的开发提供了捷径

dds调试源代码，已经调试好的，可以直接使用，谢谢！-dds debug source code, debugging has been good, and can be used directly, thank you!

本程序是通过单片机进行电机的控制，可以控制电机的转速，前进和倒退。单片机通过串口接收来计算机的控制信号(可以采用无线方式进行串口的通讯)。工具采用的是“韦福”的仿真软件。-this procedure through the MCU for motor control, control of the motor forward and retrogression. SCM through the computer serial port to receive the control signal (which can be used for wireless serial communications). Tools used the "ru" simulation software.

freescale s12 红外遥控小车-freescale s12 IR remote control car

温度控制器V1.5 显示为三个共阳极LED 温度传感器用单总线DS18B20 CPU为2051，四个按键，分别为UP，DOWN，SET 温度调节上限为125度，下限为-55度 只能用于单只18B20-Temperature Controller V1.5 show for a total of three LED anode temperature sensor with single CPU for the bus DS18B20 2051, four keys, respectively UP, DOWN, SET temperature regulator ceiling of 125 degrees and lower limits of-55 degrees can only be used solely 18B20

HCS08例程：本程序是PWM模块的例程，所用资源为单片机内部TPM模块，所接器件为LED-HCS08 routines: This procedure is routine PWM module, the resources used for the single-chip internal TPM module, the access device for the LED

8位LED显示驱动芯片MAX7219的驱动程序-eight LED display driver chip MAX7219 driver

LPC2368 USBHID例程，加以详细的注释，可以方便有需要的朋友-LPC2368 USBHID routines, to be detailed in the Notes, to facilitate a friend in need

八路抢答器，有计时功能，计分功能当有选手抢答时可以显示台号-Octal Responder, with time-keeping. Scoring function

c8051f020里面自带的温度传感器的使用程序，经调试通过。-C8051F020 own temperature sensor inside the use of procedures adopted by the debugger.

spi设备uclinux驱动源代码，以及编译后的2进制文件。-spi-driven equipment Basis source code and compiled 229 of the two documents.