C51 CAN开发测试软件和驱动程序，带相关开发文档

学习C51时写的定时器程序,提供给刚学单片机程序的朋友参考-C51 when learning to write timer procedures, available to just school friends Singlechip procedure reference

本模拟I2C软件包包含了I2C操作的底层子程序，使用前要定义好SCL和SDA。在标准8051模式(12 Clock)下,对主频要求是不高于12MHz-The simulation package includes I2C bottom I2C operation subroutine, before the definition of a good use of SCL and SDA. 8051 in standard mode (12 Clock), the requirements for the frequency is higher than 12MHz

关于9s12单片机的课件 重点是编程语言和环境-on 9s12 SCM courseware focused on programming language and environment

摩托罗拉单片机的定时器溢出中断的原代码-Motorola MCU overflow timer interruption of the original code

为了进一步理解上述方法如何在编程中得以实现，在此提供了1个用C51单片机编程语言编制的8个按键的键处理程序，以供参考。该程序在KEIL C51 V6.02/uVsion2 demo编译环境下编译通过-In order to further understand how the above method to realize programming, provided in the C51 single-chip microcomputer with a programming language produced by the eight key key procedure for reference. The program in the KEIL C51 V6.02/uVsion2 demo compiler compiler environment through

普通IO口模拟RS232串口 占用定时器0中断 在TH0,TL0中设置波特率的大小 注意不要开定时器0的中断，这里用的是查询方式-ordinary RS232 serial I simulated occupancy Timer 0 interrupt the switching, TL0 set baud rate to the size not to open the Timer 0 interrupt here with the inquiry

开票盖章系统设计开发环境为ICC,可以编译成汇编,直接下栽到嵌入式avr单片机进行控制-drawer sealing systems design and development environment for the ICC, can compile a compendium, Embedded directly to the downward avr microprocessor control

lcd显示keil源码-lcd demonstrates the keil source code

Tinyos flood algorithms in NesC

uCOS-IImsp430型