avr单片机的12864Lcd程序，实现文字的嵌入式显示，proteus仿真

一个电子产品开发时的部分c代码D!绝对能用!-When an electronic product development part of c code D! Absolutely can!

单片机最小系统，两位LED数码管由串口输出接两个164驱动，Lout,Rout为左右声道输出，SET， ALT0， ALT1为三个按键，也可自己在开始的I/O定义改成你想用的I/O口；12M晶振，若用89C51则只可装下约14首歌曲，用89C52则可装下近40曲-The smallest single-chip system, the two LED digital tube by the serial output driver 164 then two, Lout, Rout output for the left and right channels, SET, ALT0, ALT1 three buttons can also be their own at the beginning of the I/O definition change you want to use the I/O port 12M crystal, if one uses a 89C51 only loaded about 14 songs can be loaded with 89C52 under near 40

QG8_demo学习板开发板例程 显示的例程，辛苦找来。 经过验证是正确的。-Board development board QG8_demo learning routine shown in routine, it is tough to get a large. Verified to be correct.

WG12864驱动程序 模块已经定义好 直接调用就可-WG12864 driver module has been good definition can be called directly

51单片机的IIC总线先测试程序，C语言编写，很实用的！-51 MCU IIC bus test procedures, C language, it is useful!

8051 Iruma程序，包括串和转换、数码管驱动、ADC、BCD、16x2液晶、串口通信、服务器驱动等。我准备的。

• 状态1：8个LED发光二极管依次点亮。 • 状态2：8个LED发光二极管全亮后，则全部熄灭。 • 状态3：循环上述两个状态。-err

端口控制发光二极管亮灭。 【硬件连接】通过SPCE061A的1位I/O端口（本例中使用IOA15端口），经一限流电阻后接一个发光二极管至地-Port control to eliminate bright light-emitting diodes. [] Through SPCE061A hardware connection of an I/O port (in this example, the use of IOA15 port), with a current limiting resistor followed by a light-emitting diodes to land

AVR单片机,Protues仿真文件,检测按键,点亮LED-AVR Single Chip, Protues simulation document, test button, LED light

ATMEGA128的串口驱动程序，对自己编写端口驱动的同志有很大的帮助！-ATMEGA128 serial driver, port driver of their comrades in the preparation of great help!