该程序为USB HUB程序，其作为开发USB HUB类型的产品很有帮助。

Start PSC1 in 1 ramp mode using P-Start PSC1 in ramp mode using a P

C Flash Drivers for the AT89C51RD2_ED2_ID2 for Keil Compiler rev 1

AVR简单的串口程序，适合初学者学习，可以直接应用-AVR simple serial program, suitable for beginners to learn, can be applied directly

TG12864液晶显示程序，适合51,AVR,ARM等，方便做下位机开发。-LCD TG12864 procedures, suitable for 51, AVR, ARM, etc. to facilitate the development of machines to do the next bit.

AVR mega8 单片机操作CC1100的例子-AVR mega8 MCU and CC1100 RF IC

本装置是一个以HT46R71D 为主芯片，配合传感器组成的汽车轮胎气压检测装 置，最终取高三位有效值于LCD 显示，有四种显示单位供切换（Psi、Bar、Kpa、 Kgf/cm2）。本装置仅为参考范例，使用时，为提高准确度，建议多量测些组数 据来构建Sensor Output Voltage - Discharge Time (V-T)表格，并作相应校准。-This device is a HT46R71D-based chips, with sensors detecting vehicle tire pressure devices, and ultimately take the high-three RMS in LCD display, there are four types of display units for switching (Psi, Bar, Kpa, Kgf/cm2). Only reference to an example of the device, when used to improve the accuracy of the proposed多量measured set of data to build more Sensor Output Voltage- Discharge Time (VT) forms, and the corresponding calibration.

使用汇编语言的89C2051LED显示程序源码-The use of assembly language source 89C2051LED display program

ST-LINKII-KEIL 驱动 拷贝到keilarmin目录下 keil 3.22a以上版本-ST-LINKII-KEIL-driven copy to keilarm in directory keil 3.22a above

HT1621驱动程序~~内带清屏，和4为自加1显示（3COM ，1/2偏压）-HT1621 driver ~ ~ within the zone clear screen, and 4 plus a self-display (3COM, 1/2 bias)

C++ Buider下控制USB设备的例程。目标板为C8051F开发板，可通过此程序控制目标版上的LED，读取开发板上的数据。-C Buider USB devices under the control of programming. C8051F target board for the development board, through this process control objectives version of the LED, the development board to read the data.