单片机扩展flash盘

AVR_Meag8单片机控制三基色的LED，C源代码，包含电路原理路。-AVR_Meag8 single-chip control of trichromatic LED, C source code, including the principle of the road circuit.

c51程序集，适合有一定基础的人做为学习和提高用。-C51 assembly, suitable for people who have a certain foundation for the study and improve with.

单片机时钟芯片DS1302的控制程序，还有液晶的驱动-Single-chip clock chip DS1302 control procedures, as well as LCD driver

at89s51的中文资料，方便单片机初学者学习参考，并且翻译质量基本上可以。-English at89s51 of information for beginners to study single-chip reference, and basically the quality of translation.

锯齿波信号发生器 函数信号源采用数字存储方式存储一到几个周期，再用时间计数，循环执行的方法实现函数信号的连续输出 -Sawtooth signal generator function signal source using a digital storage means to store some cycle, then the time counting, the method of implementation cycle of the implementation of the continuous output function signals

三相步进电机的三相六拍工作方式，正转的绕组通电顺序：A、AB、B、BC、C、CA、A，反转的通电顺序：A、AC、C、CB、B、BA、B、A。 由于步进电机转子有一定的惯性以及所带负载的惯性，故步进电机的工作过程中不能及时的启动和停止，在启动时应慢慢的加速到预定速度，在停止前应逐渐减速到停止，否则，将产生失步现象。 步进电机的控制问题可总结为两点： 1、产生工作方式需要的时序脉冲； 2、控制步进电机的速度，使它始终遵循加速、匀速、减速的规律工作。 -Three-phase three-phase stepper motor six shot work, is to order the winding power: A, AB, B, BC, C, CA, A, reverse the order of power: A, AC, C, CB, B, BA, B, A. As the stepper motor rotor has a certain degree of inertia, as well as brought about by the inertia load, the stepper motor during the course of work should not start and stop time, start to be slowly accelerated to a predetermined speed, the stop should be to slow down gradually to the stop, otherwise, will result in out-of-step phenomenon. Stepper motor control problems can be summarized in two points: one, resulting in the need to work the timing pulse 2, control the speed of stepper motor, so that it always followed acceleration, velocity, deceleration of the law of the work.

Arduino的步进电机控制，可以控制一个步进电机的方向，速度，内带stepper函数，可以直接调用-Arduino

基于430单片机的DS18B20测温系统-Based on 430 single-chip temperature measurement system of DS18B20

rc500 c语言库函数，对RC500的开发提供了捷径-rc500 c language library functions, the development of RC500 provides a shortcut

msp430+469的C程序-Controller 469 C procedures