TS 传输流的同步检测模块，该模块可以完成对输入的ts流的同步头检测和跟踪功能

此代码能够使得键盘控制液晶，实时的进行书写，按下Backspace清屏(This code enables the keyboard to control the LCD, in real-time writing, press Backspace clear the screen)

i2c的systemverilog vip，功能齐备，架构简洁她是用SystemVerilog写的验证模型，支持master和slave模式，支持stop bit和start bit的产生

说明：  基于FPGA的w5300开发代码，使用与w5300芯片，目前代码已经经过长期测试(W5300 development code based on FPGA, using W5300 chip, the code has been tested for a long time)

基于FPGA设计的一个PID控制系统，完成对物体检测和运动控制；直流电机和步进电机驱动模块是可选的。(PID control system based on FPGA: Objection detection, movement control, motor driver is optional)

matlab代码，利用Farrow结构设计分数延时滤波器，滤波器阶数和个数可分别进行设置，利用最大最小准则近似(Matlab code, using Farrow structure design fractional delay filter, filter order and number can be set separately, using the maximum and minimum criterion approximation.)

将VHDL程序下载到DE2开发板，引脚分配时需要知道的芯片每个引脚功能(VHDL program will be downloaded to the DE2 development board, you need to know when the pin assignments for each pin of the chip functions)

M25P64-SPI-FLASH芯片的FPGA控制程序，已仿真验证(M25P64- SPI- FLASH chip FPGA control program, simulation)

NCO 代码设计 使用VHDL语言 (nco)

Quartus环境下的7段扫描显示电路的源程序(Quartus environment of the seven scanning display circuit of the source)

pcf8563，在quartusII下VERILOG编写的数字时钟程序，8位数码管显示(pcf8563, written in quartusII VERILOG digital clock program, eight digital display)