红外信号测试软件

SD卡读写程序 1. sdconfig.h: 该文件为SD卡读写模块配置头文件，用户可根据实际硬件条件进行修改. 2. SD目录: SD卡读写模块的全部文件,一般不用修改. 3. 建议sdconfig.h文件不要放于SD目录中，因为SD目录中的文件一般无须修改, 而sdconfig.h通常会有改动.-1. Sdconfig.h: The document for the SD card reader module configuration header files, the user hardware according to actual conditions can be modified. 2. SD directory: SD card reader module of all the documents, the general need not be amended. 3. Proposed sdconfig. h files directory should not be put in SD because SD files in the directory are not normally required to be amended and the changes are usually sdconfig.h.

16C554 x25045应用程序 支持4个串口同时收发-16C554 X25045 DRIVER

液晶选用南京国显的12864，这是本人初次点亮液晶的程序-LCD Nanjing State selection marked 12864, this is my first lit LCD procedures

基于凌阳八位单片机的快速编程手册，可以让你较短时间掌握编程的便利。-Sunplus based on eight single-chip Fast programming manual, which will let you have a relatively short time to facilitate programming.

本程序实现通过BDM方式访问MOTOROLA 9S12单片机EEPROM，可自动配置波特率，包含读、写、擦除三种功能。-This procedure, through BDM realize MOTOROLA 9S12 Singlechip access EEPROM, can automatically configure the baud rate, including reading, writing, erasing three functions.

LCD C 文件请看看是否合适、请给我加分 第一次上传文件-LCD C requested documents to see if appropriate, please give me extra points first upload documents

单片机实现直流数控稳压电源,可调电压为0-9.9伏,步进为0.1伏-NC regulators realize single-chip DC power supply, adjustable voltage of 0-9.9 V, step 0.1 V

at89c51 读取写入24c64的C源代码-24c64 read write AT89C51 the C source code

锁定键盘的程序,程序中设定了密码正确标志,在编译软件中编译成功.-keyboard lock procedures, procedures set password correct signs, the compiler software compiler success.

NOKIA N1600 显示屏全套开发资料,包括原理图,FPC及LDS184的测试程序,需要了解3线SPI的朋友可以参考.-display full development information, including drawings, LDS184 FPC and the testing procedures need to understand three- SPI friends reference.