利用串口和单片机进行通讯,VC用对话框实现

无线NRF905(PTR8000模块)源程序+原理图DDB+图片 环境：ICCAVR MEGA16L＋11.0592M 讯通的PTR8000和PTR8000+模块，内部芯片是nrf905 SPI方式操作，有详细注析 -Wireless NRF905 (PTR8000 module) source+ schematics DDB+ picture environment: ICCAVR MEGA16L+11.0592 M RoadShow" s PTR8000 and PTR8000+ module, internal chip is nrf905 SPI mode operation, a detailed analysis of injection

利用串行驱动数码显示每位从0显示到F，到灭循环显示，要求1秒更新一次。-drive using serial digital display shows each from 0 to F, to eliminate cycle, a request updated seconds.

采用单片机控制的cs8900芯片的驱动和TCPIP协议栈-using micro-controller chip the cs8900 drive and TCPIP stack

液晶显示器与单片机接口电路程序，实现液晶显示对于信号源发生信号的控制和显示-LCD and microcontroller interface circuit procedures, LCD occurred signal source for the control signal and display

这是一个实现串口通讯,发送与接收的源程序。用最简单的方法进行串口调试-This is a Serial communication, send and receive the source code. The simplest way to use serial port for debugging

利用单片机测频率-frequency measurement using SCM

凌阳61 的1602液晶显示程序 引用头文件就行-61, 1602 Sunplus LCD procedures quoted header file on the line

温度测量程序，包括显示、数据采集、进位、延时、数摸转换-temperature measurement procedures, including display, data acquisition, rounding, delay, a few touch conversion, etc.

8051F_Modbus.rar是在C8051F020单片机上编写的ＣＲＣ１６校验的MODBUS协议.-C8051F020 Singlechip 8051F_Modbus.rar is prepared CRC16 checksum of the MODBUS protocol.

小日本用mega8 做的软件模拟USB 转232-Little Japan mega8 do with software simulation USB transfer 232