一个用单片机控制饲服电机的程序，采用ＯＭＲＯＮ光纤感应器实现的剪纸机，已通过调试...

用凌阳单片机输入频率控制并输出14位2进制码锁住相应频率-With Sunplus Singlechip frequency control input and output 14 2 hexadecimal code corresponding frequency locked

基于单片机的电子导游系统设计,采用了miniC-A101FS和单片机AT89C2051配合使用。-Based on single-chip electronic guide system design, using miniC-A101FS and use single-chip AT89C2051.

240*320 TFT LCD的AVR驱动程序，LCD控制芯片ILI9320 并行16bit模式 -240* 320 TFT LCD of the AVR driver, LCD controller chip ILI9320 parallel 16bit mode

atmage8中的I2C口读写程序，希望对大家有用！-I atmage8 of I2C reading and writing process, I hope useful for all of us!

用并口通信时,只需发送仿真软件的十六进制显示窗口的第四个字节后的所有数据。 如:清全屏的十六进制显示窗口是55AA0001434C42,采用并口通信时只需发送434C42-with Parallel Communications, only this simulation software hexadecimal display window of words, after the data. Such as : a full-hexadecimal 55AA0001434C42 show window is used and only parallel communication sent 434C42

红外信号测试软件-infrared signal testing software

MPLAB Simulators 高级仿真教程。-MPLAB Simulators advanced simulation tutorial.

pROFIBUS 从站源程序 SPC3 pROFIBUS 从站源程序 SPC3 -PROFIBUS slave source SPC3 pROFIBUS source from the station SPC3

CAN三台机子互相通讯（机子2程序），已调通，标准的标识符，11位。-CAN communication with each other three loom (loom 2 procedure), Qualcomm has been transferred, the standard identifier, 11.

一个单片机控制继电器的程序。用C编，可实现一定的基础控制功能