windows环境下的串口调试工具。具有配置串口,自动接受,手动发送数据的功能....

VC编程实现的串口通信，界面简洁，实现基本的串口通信的作用。-VC programming of serial communication, the interface simple to achieve a basic serial communication role.

一个队串口进行操作的程序，可以作为学习串口编程的资料-A team to carry out the operation of serial procedures, can serve as a learning serial programming data

串行口是计算机一种常用的接口，具有连接线少，通讯简单，得到广泛的使用。常用的串口是RS-232-C接口(又称EIA RS-232-C)它是在1970年由美国电子工业协会(EIA)联合贝尔系统、调制解调器厂家及计算机终端生产厂家共同制定的用于串行通讯的标准。它的全名是"数据终端设备(DTE)和数据通讯设备(DCE)之间串行二进制数据交换接口技术标准"该标准规定采用一个25个脚的DB25连接器，对连接器的每个引脚的信号内容加以规定，还对各种信号的电平加以规定。传输距离在码元畸变小于4%的情况下，传输电缆长度应为50英尺。 　　Linux操作系统从一开始就对串行口提供了很好的支持，本文就Linux下的串行口通讯编程进行简单的介绍.-computer serial port is a common interface, with connecting lines, simple communications, to be widely used. It is commonly used serial RS-232-C interface (also known as the EIA RS-232-C) it is in 1970 by the American Electronics Industry Association (EIA) Joint Bell System, a modem manufacturers and computer terminal manufacturers developed for serial communication standards. Its full title is "data terminal equipment (DTE) and data communications equipment (DCE) between serial binary data exchange interface technology standards," the use of a standard 25 feet to the DB25 connector, the connector pin of each signal content requirements, but also the right signal--

一个模拟主站的CDT调试工具。可以根据需要来设置同步字，控制字，信息字的颜色。挺好用的。-A simulated Master Station CDT debug tools. May be needed to set the synchronization word, control word, the color information word. Very good use.

串行口uart-rs232不带缓冲器区的显示模块，望大家给与意见-Uart-rs232 serial port with no buffer zone display module, hope you give advice

485通讯例程，供大家学习参考。 -Communications routines 485 for them to learn from the reference. Communications routines 485 for them to learn from the reference.

这是我自己写的,请各位高手看一下!!是关于串口方面的编程,用java-This is what I wrote it myself, please look at the top! ! Serial on the program, using java

4510 bios,please see it carefully!and so on,no thanks

一个简单的电脑红外遥控驱动程序，只能识别特定的红外信号（我是基于K11B遥控器编的），不能自动识别，还有一些简单的，控制其它程序的方法-A simple computer infrared remote control driver, could only identify a specific infrared signals (I was compiled based on the remote control K11B), does not automatically recognize, there are some simple method of controlling other programs

C#编写的出口读写程序，可以实现端口和波特率的选择-Written in C# export read-write process, can be achieved port and baud rate selection