端口控制发光二极管亮灭。 【硬件连接】通过SPCE061A的1位I/O端口（本例中使用IOA15端口），经一限流电阻后接一个发光二极管至地...

红外资料，详细的介绍了一些红外的资料，内容比较详细-Infrared data, a detailed introduction a number of infrared data, content in more detail

51 与PC串口通信，IO口模拟串口显示，-AT892051

M16Uart 实验现象: 通过超级终端或者是串口调试助手向单片机发送数据,以*开始#结束 单片机储存的是*#之间的数据, 发送R可将单片机最近一次记录的数 据传送给PC机,接收到新的数据,以前的数据将被清除, 数据长度在 255个字节以内-M16Uart experimental phenomena: The HyperTerminal or a single-chip serial debugging assistant to send data to* the beginning of# The end of single-chip storage is*# Between the data, send R may be the last single-chip record data transmitted to the PC, to receive new data, previous data will be cleared, the data length of 255 bytes or less

详细介绍了单片机的总线设计法，讲述清除并有设计实例-Details of the MCU bus design method, and a design example about the removal

TELEPHONO的C51程序-TELEPHONO procedures

cd4094驱动程序，驱动1位共阴极数码管，pic12c508a作为控制器，gp0-gp2分别为data,clk,strobe.-cd4094 drivers, driving a total digital cathode tubes, pic12c508a as controller, gp0-Day for data, clk, strobe.

proteus与avr结合开发的单片机程序，实现走表功能-proteus and avr microcontroller combined with the development of procedures to achieve functional walking table

对DS18b20传感器网络编码和搜索,以及对连接线的短路和开路进行检测-right DS18b20 sensor network coding and search, and the link between the short-circuit and open circuit detection

C51很好的IO模拟串口程序，也称软件UART。只需用一个定时器，实现中断接收。程序编写得很规范，有很多个晶振频率和串口频率可选。是一个比较好的软件串口程序。-C51 a good simulation of serial IO program, also known as the software UART. Just use a timer to achieve interrupt reception. Programming very standardized, there are many a crystal oscillator frequency and the frequency of an optional serial port. Is a relatively good software serial programs.

这个文件是西门子16位单片机从c166上的一些应用程序的源代码，都是用标准c语言写的-Siemens 16 microcontroller from c166 on the application"s source code, are standard written language c