JTAG 提供了简单易行的调试手段。该软件提供了简易AVR jtag迪的制作方法...

C51 TIMER 0的使用 Timer_0_mode_1_timer_gate_hard-C51 TIMER 0 use Timer_0_mode_1_timer_gate_hard

无线模块nrf2401驱动程序，介绍了NRF2401应用操作的源程序代码-Wireless module nRF2401 driver, introduced the application of the operation of nRF2401 source code

基于中断控制的声光报警器的设计.采用中断方式，设计一个声光报警器的硬件电路和控制程序。程序运行时，一旦8位开关信号量状态满足设定条件，就触发中断，使发光二级管按规律闪烁，同时扬声器播放一段音乐。 硬件设备包括一台微机、一个MFID微机实验箱、一块T型板，2输入四与门 74ls08、8位总线驱动器 74ls245、LM386A音频放大器、排阻、扬声器各一个，发光二极管8个，470uF电容2个、104电容4个，插线若干。 -Interrupt-based control of sound and light alarm design. Using interrupt mode, designing a sound and light alarm hardware circuits and control procedures. The program is running, once the 8-bit switch signal to set the amount of state to meet the conditions to trigger interrupts, so that light-emitting diode flashes according to the law, while speakers play a piece of music. Hardware includes a computer, a computer simulation, MFID box, a T plate, 2 input 4 and gate 74ls08, 8-bit bus driver 74ls245, LM386A audio amplifier, exclusion, speakers of a light-emitting diode 8, 470uF capacitor 2 a, 104 capacitors 4, plug-line number.

用ATmega16实现对74HC595的驱动，并用INT0实现一键休眠-With ATmega16 realize 74HC595 driver, and used to achieve a key sleep INT0

这是一个BCD码的加法的实现程序..用途很广在单片机领域-This is a BCD addition to the realization of the procedure .. uses a wide area in SCM

单片的得isp实现的全部资料。大家看看阿，不错哦，好东东阿。-isp single in the realization of all the information. A look at you, yes, oh good Dong Ah.

本程序为应用在Arm7下的Ps2键盘接口程序。避免了因多中断而数据出现错误的情况-This procedure is used in ARM7 under the Ps2 keyboard interface program. To avoid interruption caused by more than the case of data error

ATMEL Uart C51程序（中断方式）-ATMEL Uart C51 (interrupt)

此程序为单片机和PC机RS232传输时候的C51源码!实现单片机中断程序发送,接受功能.-procedure for a microcontroller and PC RS232 transmission when the C51 source! MCU interrupted proceedings to send and receive functions.

C语言编程宝典。开发c51单片机的工具书-C language programming book. C51 MCU development tool