ad9851的串行输入控制，用c编写的凌阳单片机程序

功能：实现对DS18B20的读取 原理：单总线协议 注意：单总线协议对延时要求比较严格，此程序中采用的是11.0592M的晶振，如果使用其他的晶振请跟据DS18B20的资料修改延时参数-functions : to achieve DS18B20 read Principle : single-bus protocol attention : single-bus protocol to delay requirements more stringent, this procedure is used in the crystal 11.0592M if the use of other crystal please According to the information DS18B20 delay parameter changes

控制小车用PWM方式来控制小车的转速，小车的步进电机需要用直流电机控制，因为单片机产生的电流小，需要驱动-Vehicles with PWM control mode to control the car

SST39VF080 FLASH的单片机驱动源代码，可直接复制到uVision中验证，开发的单片机芯片为80C51-SST39VF080 FLASH microcontroller-driven source code, can be directly copied to verify uVision to develop chips for the 80C51 microcontroller

实现68013系列芯片进行BULK传输的程序-achieve 68013 series chips BULK transmission procedures

MCU与PC键盘通信程序，接口为PS/2；I2C通用驱动程序-MCU with a PC keyboard communication procedures, interface for PS/2; I2C common driver

avr之IDE驱动程序-avr Zhi IDE driver

版本：1.0 Target：89S51 程序描述：这个程序利用89X51连接绘图型LCD，然后显示出：-Version : 1.0 Target : devised procedures Description : The program uses 89 X51 graphics link-LCD, then showed :

LCD12864,T6963控制器的C源程序-LCD12864, T6963 controller C source

仅供参考 仅供参考-only reference is for reference only reference is for reference only

MT8888芯片的C51读写程序-MT8888 chip C51 literacy procedures