arm　s3c44b0x 的程序源码

资源描述Key.c和Key.h  源文件实现了按键长按、短按、长按累加的识别，采用状态机制来实现按键消斗和不同按键状态识别，最大限度提升程序的运行效率和MCU利用率，该代码移植性，支持IO驱动按键，AD采样方式识别按键。采用DMA的方式获取AD采样数据，MCU采用STM32.

FIC8120 方案 Multi-ICE-FIC8120 program Multi-ICE

国外网站上的一些精典的C程序，欲炼神功，必先从基础开始，希望初学者能够多打好基础,特别是做嵌入式程序,重复也要传！BTW,欣赏站长的一些诗！-foreign web sites of some of the classic C procedures and wishes refining art, we must first start from the basis of the hope that more beginners to lay a good foundation, especially so embedded procedures must repeat Biography! BTW, director of the appreciation some poetry!

本程序,利用51单片机AT89C51来读写多功能芯片X5045的源程序-This procedure, using 51 to read and write AT89C51 single-chip multi-chip source X5045

三星S3c2410 的 GPIO控制程序. GPIO的控制是所有嵌入式开发的基础,GPIO掌握了,才能再磁基础上深入. -of GPIO control procedures. GPIO control is all embedded development base Hence, the GPIO master, can we further on the basis of magnetic-depth.

s3c2440 温度试验 测试代码 wince5.0-s3c2440 temperature test test code wince5.0

基于s3c44b0x的ps2接口驱动程序-based on the ps2 s3c44b0x Driver Interface

基于ARM的定时器中断实现-timer Interrupt

本人亲手实现且用在一商用产品上的一个简单的ppp协议，针对Arm7TDMI-I personally can be used to achieve a commercial product in the ppp a simple agreement against Arm7TDMI

HCS08例程：本程序是TIMER模模块的例程，所用资源为单片机模定时器MTIM，所接器件为LED灯，其中D2与PTA0，D3与PTA1相连接！-HCS08 routines: This procedure is routine TIMER mode module, the resources used for the single-chip mode timer MTIM, the access device for the LED lights, which D2 and PTA0, D3 and PTA1 connected!