Keil_C51程序,C8051实现的TCP/IP功能源码，使用keilC51，含网页测试程序。...

本程序是通过TMS320CS2047的DSP处理器,经过DSP内部事件管理器的配合,实现SPWM波输出!-This procedure is adopted TMS320CS2047 of DSP processors, DSP, after the internal event manager with the realization of SPWM wave output!

在Arm源代码中使用SD卡，源代码用keil编译器编写，

LPC2104写的一个串口程序，可以帮助初学ARM的人。-LPC2104 write a serial program that can help novice ARM person.

用单片机为电饭锅做“手术”。 汇编文件，带dsn 仿真-For the rice cooker to do with single-chip " operation."

2812使用spi读写fm25cl64或者at25640的程序，已经测试通过。注意在在eeprom的datasheet中都写只支持spi的0或者3模式，但我用0模式一直调不通，改用spi模式才可以，程序中就是使用spi的1模式。-2812 to read and write using spi or at25640 procedures FM25CL64 have the test. Attention to the datasheet in the EEPROM are write only support spi mode 0 or 3, but I used the 0 model has been adjusted barrier before they can switch to spi mode, process is the use of one mode of spi.

此源码是sc3c2410串口测试程序，经实际测试，可以正常运行．-This source is sc3c2410 serial test procedure, the actual test can be normal operation.

卡车仪表的单片机程序，使用的是ICCAVR环境，用的是ATmega8芯片。-Singlechip truck instrument procedures, using ICCAVR environment, using the ATmega8 chip.

bios源码-bios source code

EasyARM2131开发板源码之一-----------6.GPIO输出实验-LED数码管显示0-F字符，同时控制LED1、LED2、LED3、LED4显示对应的16进行值-EasyARM2131 one source development board----------- 6.GPIO experimental output- digital LED Display 0-F characters and control LED1, LED2, LED3, LED4 shows the corresponding values for 16

阿尔派6碟CD换碟机控制协议,不是全本，是某人的实测码，个人认为有一定的参考价值。-Alpine 6 disc CD changer control protocol, not all of this, a person" s measured yards, personally think that there is a certain reference value.