凌阳的液晶驱动 61板，大家自己看看吧

单片机实用子程序汇编代码-SCM practical subroutine code compilation

1.ARM芯片LPC2148的RTC源码 2.ARM芯片LPC2148的DS18B20C驱动源码 3.ARM芯片LPC2148的TIMER0中断驱动源码-LPC2148 chip 1.ARM the RTC source 2.ARM the LPC2148 chip DS18B20C drive LPC2148 chip 3.ARM source of Timer0 interrupt-driven source

氦浓度检测仪 氦浓度检测仪-Concentration of helium detector helium concentration detector

用于51系列的高精度的实用延时程序，是编程的很好参考资料。-51 for a series of high-precision delay practical procedures, programming is a good reference.

Proteus环境下DAC0832数模转换程序与电路.-Proteus environment DAC0832 digital-to-analog conversion process and the circuit.

自己写的ATmega16单片机驱动1602液晶的头文件，本人已测试通过，不错！-himself wrote the ATmega16 LCD Driver 1602 for the first document, I have been tested, yes!

独立数码管计数，从0到99的计数，然后再清零。比较简单的代码。-Independent digital control counts, 0-99 from the count, and then cleared. The code is relatively simple.

cw环境下例子程！ DS18B20实验 用户成功安装好CW6.0后，双击每个实验文件夹下的.mcp文件即可。 注：用户如果安装其他CW软件，一定要确保.mcp文件打开方式为CW6.0.-cw example environment-way! DS18B20 experimental CW6.0 successfully installed, double-click each folder under the experiment. Mcp files. Note: If users install additional software CW, we must ensure that. Mcp file open for CW6.0.

最近作的AD9852的FM扫频模式，自动计算频率，采用单片机的总线访问方式，非常方便，你要做 的就是填数-Recently, the AD9852 for the FM sweep mode, automatic calculation of the frequency of the use of single-chip bus access method, a very convenient, you have to do is fill in a few

采用Proteus的双步进电机 模拟仿真。-Proteus uses a dual stepper motor simulation.