430例程1：液晶显示，键盘扫描，数码关扫描显示等等，还有时钟程序...

Verilog实现的DDS正弦信号发生器和测频测相模块，DDS模块可产生两路频率和相位差均可预置调整的值正弦波，频率范围为20Hz-5MHz，相位范围为0°-359°，测量的数据通过引脚传输给单片机，单片机进行计算和显示。-Verilog realize the DDS sine wave signal generator and frequency measurement module test phase, DDS module can generate both frequency and phase difference can be preset to adjust the value of sine wave, frequency range of 20Hz-5MHz, phase range of 0 °-359 ° , measurement data and transmit them to the single-chip pin, single-chip microcomputer to calculate and display.

直接转矩电机控制，仿真程序，SIMULINK m代码实现-Motor direct torque control, simulation program, SIMULINK m code

智能车的马达控制程序,通过串口控制车的加速减速等。-This file is for Motor of Intellengence Car.

HD66789R datasheet is very good for TFT examples-HD66789R datasheet is very good for TFT examples...

无线模块nrf24l01程序，实现发送与接收功能。-Wireless module nrf24l01 procedures implementation to send and receive functions.

采用8位LED动态扫描时钟演示程序，使用12MHZ晶振，P0口输出段码，P2口作列扫描，用共阳LED数码管。-Using 8-bit dynamic scanning LED clock demonstration, the use of 12MHZ crystal, P0 port output above code, P2 scan I made out with a total of LED digital tube Yang.

单片机控制AD2543,同时通过液晶显示的程序，通过移植修改即可以应用-SCM AD2543, at the same time through the liquid crystal display procedures, through the graft modification can be applied

基于2407平台的spi串行通讯常用例程 -2407 platform based on the commonly used 20 serial communication routines

C51源程序库，一些例，学51单片机的基础用-C51 source database, a number of cases, the basis of study with 51 single-chip microcomputer

C51 TIMER 0的使用 Timer_0_mode_1_counter_gate_hard-C51 TIMER 0 use Timer_0_mode_1_counter_gate_hard