m16做的简易示波器，内含源程序和电路图 pdf格式

一个简单的利用查表法的反正切和正、余弦函数，在处理速度不快的单片机编程中，这是一个使用的方法。-The use of a simple arctangent look-up table method and positive, cosine function, the processing speed of microcontroller programming unpleasant, this is a method used.

本系统参照片上系统的设计架构、采用FPGA与SPCE061A相结合的方法，以SPCE061A单片机为进程控制和任务调度核心；FPGA做为外围扩展，内部自建系统总线，地址译码采用全译码方式。FPGA内部建有DDS控制器，单片机通过系统总线向规定的存储单元中送入正弦表；然后DDS控制器以设定的频率，自动循环扫描，生成高精度，高稳定的5Hz基准测量信号。-The system with reference to the design of system-on-chip architecture, used a combination of FPGA and SPCE061A approach to SPCE061A Singlechip for process control and scheduling core mission FPGA for external expansion, internal self-system bus, address decoding using the entire translated code approach. DDS has built internal FPGA controller, microcontroller through the system bus to the provisions of the storage unit into the sine table DDS controller and then to set the frequency, automatic cycle of scanning, to generate high precision and high stability of the baseline measurement 5Hz signal.

单片机驱动液晶程序,液晶为1624型 里面程序齐全,只需调用子程序就好-Single-chip LCD driver program, LCD-type inside the procedure for the 1624 full, simply call the subroutine like

18b20的仿真实例，希望能帮做一些初学者，-18b20 the simulation example, I hope to do something to help beginners,

arm的spi功能，通过595点亮数码管-arm of the spi feature 595 digital tube light

man, i think i can download files right for i uploaded 5 files.

ADC0809数据采集系统 ADC0809数据采集系统-ADC0809

用汇编语言编写的超声波测距控制源程序采用AT89S51,12ＭＨz晶振 -Prepared by using assembly language source code control using ultrasonic ranging AT89S51, 12MHz crystal

嵌入式通用EEPROM读写程序.-embedded EEPROM read and write common procedures.

C8051f020单片机查表源程序-C8051f020 source SCM Lookup