单片机开发升级到DSP

tms320f2812 ad采样程序 基于DEC2812-tms320f2812 ad based on sampling procedures DEC2812

dsp SCI异步串行，自动波特率设置样例-dsp SCI asynchronous serial, auto-baud rate setting example

本程序是提取语音MFCC参数的必经步骤，是求出mel三角滤波器器组的参数，网上只有matlab程序，没有C程序，本人花费两个星期的时间才转换成功，经DSP 的CCS环境调试成功。-This procedure is the extraction of voice MFCC parameters necessary step is to derive the triangular mel filter device group parameters, on-line only matlab procedures, no C program, I spent two weeks time to convert the success of the CCS environment by DSP debugging success.

CMOS 74系列芯片全部资料，写硬件程序必备的资料！-CMOS 74 series chips all the information and writing the procedures necessary hardware information!

用DSP2407编写的BLDC闭环程序，针对特殊电机，程序调试好用-Written in closed-loop BLDC with DSP2407 procedures, for specific motor, easy to use program debugging

CCS中有关PIPE管道操作的例子，已经经过调试-CCS operation of the pipeline PIPE example, after debugging

本案例实现DSP TMS2812控制液晶显示屏,简单，实用，是学习显示控制很好的例子

信号处理的小波引导对于学习用小波分析进行信号处理的学者非常有用-Wavelet signal processing to guide for learning signal processing using wavelet analysis is very useful for scholars

可以在arm和dsp上跑的mpeg4解码代码。 读取文件格式是YUV-Arm and dsp can run code of mpeg4 decoder. Read the file format is YUV

源程序是在VisualDSP环境下开发出来的，目标处理器是4片AD公司的TS1O1 DSP。IDE_FAT32用来在硬盘上创建FAT32文件系统；2）i2c_test编写IIC总线；3）codec_a_in_pal_cf_frame是加载到FLASH的程序，板子在脱离PC自动上电时会把PAL制的图像直接存到CF卡里，CF卡的文件系统是FAT16；4）codec_a_in_pal_buf_boottest是可加载的DSP图像直通程序；5）ADSP-TS101prog_driver是flash的驱动程序。-source of the VisualDSP environment developed, targeted four processor is the company"s AD TS1O1 DSP. IDE_FAT32 used in the drive to create FAT32 file system; 2) to prepare i2c_test IIC bus; 3) codec_a_in_pal_cf_frame FLASH is loading procedures, the board automatically from the PC on when power will be the PAL system images directly to CF card, the CF card is the FAT16 file system; 4) can be loaded codec_a_in_pal_buf_boottest DSP image through procedures; 5) ADSP-TS101prog_driver flash is the driver.