LPC2294 ARM7 UART 测试程序

使用了nvic提供的irq控制函数来进行原子访问的保护，提供了cortex m系列芯片的简单word单位的ring  ring buff，这个buff可以用来在中断和前端程许2间交换数据                                                                                                                                  

15个Altera的IP的源码，嵌入式开发必备-15 Altera IP source code, the embedded development required!

三星ARM2410boot代码，有一定的参考价值，在2410上BOOt成功过-Samsung ARM2410boot code, which is the reference value, in 2410, never succeeded in BOOt

at91sam7s64 usb-device iar5.3 源码-usb-device-hid-keyboard-project.rar at91sam7s64 usb-device iar5.3 源码

CPU 2410 的硬件应用程序，该源码包是IIC的使用例程。-Hardware CPU 2410 applications, the source packet is the routine use of IIC.

为了适应不同的应用,ARTX必须通过配置才能使得适合特定的应用系统.所有配 置项都在 ARTX_Config.c 文件中,此文件位于KeilARMStartup 文件夹下.通过不 同的配置,用户可以: -In order to adapt to different applications, ARTX must be configured to allow for specific applications. ARTX_Config.c all configuration items are in the file, this file is located in Keil ARM Startup folder. Through different configurations, the user can:

基于LPC76X的LIN开发通信源程序调试通过-LPC76X development of LIN-based communications through the source code debugging

S3C2410数据手册-S3C2410 Data Sheet ...................

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

基于LPC2468的嵌入式系统开发板，可做项目是参考。-LPC2468-based Embedded System development board, to do the project reference.