清华大学ARM培训教材,希望对大家有所帮助

周立功提供的基于菲利普ARM的LPC2200微控制器的图形库源程序-based Philips LPC2200 ARM Microcontrollers the graphics library source

在ATM32的平台上用IO口模拟I2C读24FC256.-Read 24fc256 in STM32 platform,Not use I2C module, but in IO simulation.

mc9s12XDP512单片机 CAN0 程序 -mc9s12XDP512_CAN0 MCU program

一个在S3C2410开发板视频采集播放程序-S3C2410 development board in a video capture player

基于ARM7的开发板的存储器重映射驱动程序，文件里有程序的详细注释，对与在此基础之上的二次开发非常方便-based on the ARM7 development board memory re-mapping driver, the documents detailed procedures Notes right and the basis of this second development is very convenient

基于ARM9的NAND FLASH（large page）的驱动，包括读写和擦除（在数据区可剩余区），读取ID号等主要功能。-ARM9-based NAND FLASH (large page) of the drive, including reading and writing and erasing (in the data area will be the remaining area), read the ID number and other major functions.

优龙ST2410的BIOS源码，支持USB传输DMA功能，支持LINUX和WICE引导，很适合学习2410处理器的裸机编程-Liuzhou ST2410 excellent source of the BIOS to support USB transmission DMA functionality, support for LINUX and Wice guide, it is suitable for studying the bare-metal programming processor 2410

Atmel arm can总线的应用程序，带详细注释-bus applications, with detailed explanatory note

for mips adm5120 uclibc-0.9.19 toolchain

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (