这不是源码，这是Protel99SE版本的 通用器件封装库，很多朋友在寻找...

本文件是ATMEGA16A的使用说明，内附该单片机内部各个资源的C代码和汇编代码-This document is the use of ATMEGA16A that the single chip containing all the resources within the C code and assembly code

通过日期算星期的C51源程序,用c写的小程序 希望对大家有用-through weeks of the date of counting source of C51, with a small c written procedures hope useful for all

蜂鸣器响 改变蜂鸣器的频率，通过改变延时时间 蜂鸣器的时间要是是靠延时来完成的-Buzzer buzzer ring to change the frequency by changing the delay time if the buzzer is the time to be completed by the time delay

ID读卡程序,在可以读取ID卡卡号,判断身份,在门禁考勤大量应用-ID card reader, and in the can read ID cards card number, as judge, in a large number of applications are disucssed

320*240液晶 用SEED1335控制的驱动-320* 240 LCD driver control with SEED1335

瑞士盛世瑞恩数字温湿度传感器SHT11的完整程序 开发环境为KEIL-Switzerland Sensirion digital temperature and humidity sensor SHT11 a complete program development environment for the KEIL

这是一个在proteus下仿真成功的闪烁灯的例子。对于初级学习proteus的人很有帮助-This is a simulation in proteus success under the lights flicker example. For the initial study and the people very helpful proteus

基于stc89c52实现具有校时模式、定时模式，能够显示月、日、星期等功能的电子钟。-When the realization of the school-based stc89c52 mode, timing mode, can display month, day, week, and other functions of the electronic clock.

利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"。到此保持住。 设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital control to show from the beginning of 765,432 to 1/10 seconds until the speed of descending down 765,398 and maintain display this number, at the same time the use of Timer 0 to 500ms the speed of light from the flowing water to Under the move, when reduced to a few digital tube stop, the experiment on-board water stop and then all the lights started to flicker, 3 seconds later (T0 regularly used) closed water lights, digital tubes show

玩具小车，设计，AT85c52,c语言设计，无线控制-toy car, design, AT85c52, c language design, wireless control