CF8051F040开发板的SRAM_rw_test 程序

CAN的调试程序。CAN的初始化重要包括下面几个方面。RXB0SIDH，RXB0SIDL，RXB0MIDH，RXB0MIDL。这是接收过滤器。TXB0SIDH，TXB0SIDL，TXB0DLC，这是发送标志位。还有波特率寄存器。操作模式为 正常模式。-CAN debugging procedures. CAN initialization important aspects include the following. RXB0SIDH, RXB0SIDL, RXB0MIDH, RXB0MIDL. This is the receiver filters. TXB0SIDH, TXB0SIDL, TXB0DLC, it is sending signs spaces. There baud rate register. The normal mode of operation for the model.

串口控制8路舵机程序,本程序适用于III型实验板，如有需要请与我联系-Serial 8-way steering control procedures, this procedure applies to type III board and, if necessary, please contact me

LTPS QVGA LCD Driver

全量程交直流无档电压表的设计 这里只给出了系统设计的方案 带有程序流程图-Wide-range AC-DC voltage meter free stall design here only gives the system design program with a program flow chart

18F的ECAN源代码,调试通过,使用C18编译器.-18F of the ECAN source code, debugging through the use of C18 compiler.

凌阳的液晶驱动 61板，大家自己看看吧-Sunplus LCD driver 61 boards, we could see for himself now

这是微软的一个USB块传输例程，虽然它是基于Intel USB开发板的，但是也很值得我们好好的研究。-This is a Microsoft USB block transmission routines, although it is based on the Intel USB development board, but also worthy of our good look.

a flight control description with mikrocontroler and DC motors

Discription: This multi-master driver provides the software interface to the I2C Bus hardware of the M3062x series of MitsubishiMCU.

CAN 程序使用MCP2515 由STM32做主芯片控制-CAN program use MCP2515 the mater chip is STM32