学习C51的最好例子程序

LT_1B msp430开发板例子程序－UART08_096-LT_1B msp430开发板例子程序－UART08_09600

基于NRF905的无线温度上位机界面及单片机程序-Based on temperature NRF905 wireless PC interface and single-chip program

基于ＳＴＭ上的122x32液晶显示程序显示图形及汉字，已经通过验证-Based on the STM on the 122x32 graphic LCD display and the Chinese characters, has passed validation

Scart To Tv 的源代码,作为接口转换是个很好的参考代码-Scart To Tv source code, as Interface Converter is a good reference code

这是由C51单片机实现的接触式IC卡的读写-This is achieved by the C51 single-chip contactless IC card read-write

用Ｃ编写的５１单片机小工具，对于开发的人员来说帮助不小-51 prepared with C Singlechip small tools, for the development of personnel for help is not a small

系统can地址为550,用于can系统测试,应用T0定时器每隔1s向can总线发送一组数据:数据长度为8个字节, 首字节为05H,第二个字节为累加变量,每秒钟数值增加1,-system can address 550 for the test system can, Application T0 1s to every timer can send a bus of data : data length of 8 bytes the first byte of 05H, the second byte of cumulative variable, an increase in value per second.

用AVR-ATMEGA8驱动手动机器人整个控制，该程序在机器人上成功调试-AVR-ATMEGA8 drive with manual control of the robot, the program in debug robot successfully

： 8×8，16×16，至256×256大小的各种字体字母，数字，汉字点阵字库提取程序支持C51和汇编格式,232通信发送二进制文件,能把所生成的字库数据通过232串口发送出去,不用任何协议,方便单片机调试 8×8，16×16，至256×256大小的各种字体的字母，数字，汉字点阵字库提取程序,支持C51和汇编格式,232通信发送二进制文件,能把所生成的字库数据通过232串口发送出去,不用任何协议,方便单片机调试-: 8 × 8,16 × 16, to 256 × 256 size of the various fonts of letters, numbers, Chinese characters dot-matrix font support C51 extraction procedures and compilation format, 232 communications to send binary file, can the font data generated through 232 serial port to send out, without any agreement, to facilitate debugging single-chip 8 × 8,16 × 16, to 256 × 256 size of the various fonts of letters, numbers, Chinese characters dot-matrix font extraction procedures, to support the C51 and compilation format , 232 communications to send binary file, can the generated font data sent through the serial port 232, do not have any agreement to facilitate the single-chip debugging

使用ADC模块的通道0、1进行电压的测量，然后将转换结果从串口输出。-0,1-channel ADC module used for voltage measurement, and then convert the results from the serial port