lpc2368+ Ucos

在ＡＲＭ２４１０支持汇编指令集，可在Ｓ３Ｃ２４１０上运行．-ARM2410 support in the compilation instructions, the S3C2410 running.

ARM映象文件及执行机理-ARM image files and the implementation mechanism

ARM7202上通过JTAG烧录Flash的工具源代码，VC6.0下。-ARM7202 burning through JTAG tools Flash source code, VC6.0 under.

lpc2131实验１ 功能：GPIO控制实验-lpc2131 experimental one function: GPIO control experiment

Hey. This some pid code for the atmega88 that I once used to control a heater. It s purpose is pretty specific, and I only wrote it to work on the mega88, so the code itself won t be too useful. It is a good place to start if you re trying to use or figure out pid though.

44b0开发板上实时时钟的测试程序，对初学者很有帮助-44b0 development board real-time clock testing procedures, helpful for beginners

基于ARM9的嵌入式GPRS的设计与实现,用基于ARM核的S3C2410微处理器-ARM9-based embedded GPRS design and implementation, with ARM core-based microprocessor S3C2410

This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It permits you to download new code to the device over USB. This bootrom is installed at address 0x00000000 in the ARM, which means that it is the first piece of code to execute after reset. At startup, it waits for a few seconds to see if the downloader is trying to connect. If not, then the bootloader gives up control and jumps to your program. If the downloader is trying to connect, then the bootloader receives the new program over USB and writes it into flash.

Efficient C programming techniques for ARM Architecture.

基于ATMAL7X256 CS1180的SPI读写FLASH的实例(开发环境ADSv1.2)-Based on the SPI read and write ATMAL7X256 CS1180 examples FLASH (development environment ADSv1.2)