7 段计时器控制 avr 硬币付款

基于linux操作系统ATMELARM9200 开发平台的I2C总线驱动程序开发-ATMELARM9200 operating system based on Linux Development Platform I2C bus driver Sequence Development

该程序为LINUX下的串口通讯程序,采用华恒公司的嵌入式开发套件,包含了makefile文件-the procedures for LINUX serial communication program, the company used huaheng embedded development kit that includes a makefile documents

嵌入式面试指针经典 嵌入式面试指针经典 -the c program the c program the c program the c program

S3C44BOX的BIOS。可使用的命令：help --- show help ? --- = help date --- show or set current date time --- show or set current time setweek --- set weekday clock --- show system running clock setmclk --- set system running clock setbaud ------ set baud rate ipcfg ------ show or set IP address load ------ load file to ram comload ------ load file from serial port run ------ run from sdram prog ------ program flash copy ------ copy flash from src to dst address boot ------ boot from flash backup ------ move bios to the top of flash md ------ show memory data move ------ move program from flash to sdram-S3C44BOX BIOS. Use the command : help show help------------------ = help show date set current date or time or set------ show current time setweek------ set weekday show------ clock system running clock setmclk------ set system running clock setbaud set baud rate------------ ipcfg show or set IP address load------ load file to ram comload------ load file from serial port run--

PSOC UART SPI cypress 桥接功能 速度-PSOC UART SPI cypress

本程序简单的示范了如何使用ATMEGA16的定时器 AVR定时器的要点介绍 T0工作于CTC模式，输出1KHz/2KHz 50％占空比的方波 T1工作于快速PWM模式兼输入捕捉 T2工作于相位修正PWM模式，输出490Hz的8bit PWM波-This procedure simple demonstration how to use the ATmega16 timers AVR timer T0 introduce the main points of work in CTC mode, the output 1KHz/2KHz 50 duty cycle square wave T1 work in fast PWM mode Input Capture and work on phase-corrected T2 PWM mode, the output of 8bit PWM wave 490Hz

PPP协议C语言源代码，可移植到嵌入式系统上！-It is the C source file of ppp protocol that can be transplanted to embeded systems.

学习嵌入式不可多得的好书，介绍的比较详细，很适合新人学习-Learning embedded rare books, described in more detail, it is suitable for newcomers to learn

SPI_Master source code

这是一个用keil C做的动态扫描7段LED数码管程序,是用proteus做的仿真.适合初学者学习使用.-This is a keil C to do with the dynamic scan 7 LED digital tube procedure is done by Proteus simulation. Suitable for beginners learning to use.