基于MEGA16的走马灯实验，对初学者有帮助!!

毕业设计 可编程控制器 可以设定时间控制设备 程序和电路图都是正确得 -Graduation programmable controller can be set to the time control equipment, process and circuit diagrams are correct too

18B20在MSP430上测试通过程序，有需要可以下载-18B20――program

51单片机C程序,学习单片机原理、硬件结构、扩展接口和编程语言。-51 Single-chip C procedures, learning Singlechip principle, the hardware structure, the expansion interface and programming languages.

简易数字电压表可以测量0-5V范围的8路电压值，并在4位LED数码管上轮流显示或单路选择显示。-Simple digital voltage meter can measure the range of 0-5V Voltage road 8, and 4 digital tube LED display on a rotational basis or choose to display a single road.

仔细详细的介绍了msp430单片机的各个寄存器，对初学者相当的有用-Carefully detailed introduction of the MSP430 MCU in all registers, very useful for beginners

这是Beagle_Allegro_B 板子的PCB图，供大家画图时参考使用-This is the PCB board Beagle_Allegro_B map, drawing reference to use for everyone

51单片机控制网卡实现上网程序代码，编译环境为Keil C51-51 MCU control card online code, compile environment for the Keil C51

电子标签DALA-electronic labeling DALA

飞思卡尔HC08/HCS08系列单片机LCD驱动源码，希望对大家有用。-Freescale HC08/HCS08 series of single-chip LCD driver source code, in the hope that useful to everyone.

LCD图形显示函数，很使用！-LCD display function, is used!