Uart串口自发送程序,单片机自动给上位机传送数据

MSP430驱动D/A芯片DA8303 C语言程序-MSP430-driven D/A chip DA8303 C Language Program

红外遥控接收 ORG 0000H LJMP START 转入主程序 ORG 0010H START: MAIN: JNB P2.2,IR LJMP MAIN 以下为进入P3.2脚外部中断子程序，也就是解码程序 IR: MOV R6,#9 SB: ACALL DELAY882 调用882微秒延时子程序 JB P2.2,EXIT 延时882微秒后判断P3.2脚是否出现高电平如果有就退出解码程序 DJNZ R6, SB 重复10次，目的是检测在8820微秒内如果出现高电-infrared remote control receiver ORG 0000H LJMP START into main program ORG 0010H START : MAIN : JNB P2.2, IR LJMP MAIN below to enter P3.2 foot external interrupt subroutine, which is decoding procedures IR : MOV R6, SB# 9 : Calling ACALL DELAY882 882 microsecond delay subroutine JB P2.2, EXIT 882 microsecond delay after the judgment whether there P3.2 feet to I quit if decoding procedures DJNZ R6, SB repeated 10 times, the purpose is to test if within 8,820 microsecond high

USB接口芯片 FT245的ARM驱动源程序-USB interface of the ARM chip FT245 driver source

KeilC51manual

单片机控制云台，摄像头，矩阵。对做安放设备的会有很大帮助。解码器控制命令 云台/高速球控制命令 镜头控制命令 辅助动作控制命令 辅助动作控制命令-MCU control platforms, cameras, matrix. Right equipment to do the installation would be of considerable help. Decoders control commands Yuntai/ball control commands high-speed camera control commands motor control commands motor control orders

一个单片机控制无刷电机的代码程序-a brushless motor control microcontroller code procedures

实现三线控制LCD1602，并附有相关c程序，是一电子设计模块，在减少使用接口方面非常实用-The realization of three-wire control LCD1602, with c-related procedures, is a electronic design modules, to reduce the use of interfaces in a very practical

cip51 can

本文件包括葡丰概率实验测定pi的方法介绍和matlab实现方法，简单易用。-This document includes the experimental determination of the probability of Portugal Fung pi method matlab introduction and realization of methods, easy to use.

这是24L01开发头程序，希望对大家有帮阻-24L01 This is the first development process, we hope to help a resistance