液晶显示器LM24064的驱动程序，可能支大家有点帮助。

这是一个单片机c51多功能电子表程序，附带说明文档（包括硬件连线图，流程图等），绝对原创-This a multi-purpose microcontroller decoder electronic form, along with documentation (including hardware wiring diagram and flowchart), absolute originality.

用于对远方现场信号和工业设备的远程监测、控制和通讯的装置。-scene for the right signal afar and industrial equipment remote monitoring, control and communications devices.

MSP430F135与OCM12232c-2的串行显示测试程序。文字与图形分层显示。 -MSP430F135 with OCM12232c-2 shows the serial test procedure. Layered text and graphics display.

SD卡驱动 SD_CARD_TIMEOUT 当一个SD卡的操作超出时限，将导致返回错误和该标记被置位 SD_CARD_EXIST 当卡槽内插入了合适的卡体，不管是什么卡，都会使该位被设置； SD_CARD_WRITE_PROTECT 当卡体的写保护开关被 LOCK 时，则该位被设置； SD_CARD_READY 当卡槽内的卡被正确识别，并可以随时访问时，则该位被设置； SD_CARD_DOOR_CLOSE 当卡槽的门（产品外壳上的挡板开关）关闭时，则该位被设置； SD_CARD_IS_SD 当卡槽内插入的是 SD 卡时，则该位被设置。 SD_CARD_IS_MMC 当卡槽内插入的是 MMC 卡时，则该位被设置； 注意：不要使用 0x80，免得和整数作逻辑运算时被误为负数。-err

单片机stc89c52控制的1602时钟程序 包含以下文件 lesson9.c lesson9.hex-1602 microcontroller clock stc89c52 control program contains the following files lesson9.c lesson9.hex

此压缩包里为凌阳61单片机的一些简单的开发程序，-This compression bag for Sunplus 61 MCU development of some simple procedures,

MSP430的PWM的输出实现程序，非常 实用！-MSP430 output of the PWM to achieve program is very useful!

SLE4442IC卡存储程序 单片机是P89LPC9-SLE4442IC storage cards procedures SCM is P89LPC9

单片机控制语音芯片ISD1420的汇编程序，无误-Voice chip ISD1420 single-chip microcomputer to control the compilation process, correct

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to