UCGUI的汉字转换工具，直接生成GUI字体字体…

ucOS在51单片机上的移植实现， 可以跑多个任务，实现任务间的参数传递-ucOS in MCS-51 to achieve the transplant can run multiple tasks, the task of achieving the transmission parameters

该程序使用消息邮箱，在内存空间开辟了一片区域，供4个任务共享读写。1个任务在写内存时，其它任务不能读写。多个任务可以同时读该内存区域数据。(This program uses the message mailboxes, the memory space to open up a regional, shared reading and writing for the four tasks. A task to write the memory and other tasks can not read and write. More than one task can read the memory area data.)

ucos在LPC2200中的移植-CENTER LPC2200 in the transplant

uCOS-II在51单片机上的移植,用Keil 7.5编译通过,希望对移植uCOS的人以启发和帮助。-uCOS-II microcontroller in the 51 transplants, with Keil 7.5 compile, and I hope to transplant uCOS people to inspire and help.

主要在PROTUES中实现移植的一个简单程序。-Mainly in the PROTUES realize transplantation in a simple procedure.

最初学习单片机的时候，由于条件，没有硬件，就只好用Proteus仿真，其实效果蛮不错的。到后来的高版本，直接可以支持ARM。相当不错的工具。此源码是其对uCOS在ARM上运行的仿真。-MCU when the initial study, due to conditions, not hardware, they can use Proteus simulation, in fact, quite a good effect. Later versions of the high direct support ARM. Pretty good tool. This source is its uCOS running in ARM emulation.

UCOS在44B0的移植，需要一点小修改-UCOS in 44B0 transplant and will need some minor edits

在easy arm2210平台下的鸣锋器的例子-In easy arm2210 platform Ming-feng

基于ST公司低功耗产品STM32F103ZET6的红牛ARM开发板出场程序，uCOS+uCGUI(FSMC)28。(Based on ST' s low-power products STM32F103ZET6 appearance of Red Bull ARM development board procedures, uCOS+ uCGUI (FSMC) 28.)

基于嵌入式实时多任务操作系统ucos－ii的GUI的源码，精炼实用-Source code of GUI based on ucos-ii, very small and useful.