AT89S52

tcp_ip协议栈的ucos代码，主要用于嵌入式系统开发，已经移植到51系统单片机中，通过keil可进行编译，ucos经过最简化改造！特别推荐-tcp_ip CENTER protocol stack code, mainly for embedded system development, has been ported to 51 SCM system, through c51 can be compiled after the most simplified CENTER transformation! Preferred!

单片机的C语言编程应用开发程序 十分有用哦很好 的 -SCM C programming language application development process very useful oh we

nokia5110 48*84 液晶屏开发资料及各单片机例程，希望对大家有帮助-nokia5110 48* 84 LCD screen development information and the microcontroller routines, we want to help

51单片机的C语言编写的DS18B20的驱动程序，用于测试温度-51 Single-chip C-language driver DS18B20 for testing temperature

定时器0溢出中断实验，基于AVR 单片机的实验程序-Timer 0 overflow interrupt the experiment, based on the AVR MCU Experimental procedures

51单片机写的液晶显示程序（1602），调通的，供初学者参考-51 Single-chip LCD written procedures (1602), tune

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

模拟串口C51编程-simulation C51 Serial Programming

步进电机控制,LCD显示-Stepper motor control, LCD display

51单片机实现数字时钟带闹钟 使用6个弹跳按钳和4个共阴七段显示器组合而成-51 MCU digital clock with alarm